End stop upgrade – inductive

 10.00 12.00

Clear
SKU: N/A Category:

Product Description

These kits are made on order – please allow 1-2 days after order until it ships!

Tired of the optical end stops breaking or not accurate enough?
This kit contains two inductive sensors to replace your current sensors and all cables you need.
A small adapter to put between the power cable and the controller board to get external power to the sensors needed (included).

Kit contains
– Two S04-N inductive sensors
– Cables ready to plug in to your controller with JST connectors
– Power adapter for the controller board (the sensor needs external power)
– Instructions how to install

Please note, this is not a swap out kit, some modifications needed to fasten the sensors to your gantry. Super glue or hot glue is good enough as the end stops never get any mechanical force towards them. Where they should be located differs between types of K40, send a picture of your machine to get some examples of mounting.

Print Friendly, PDF & Email

Additional Information

Controller

M2 Nano, Cohesion 3D, HT-Master5/6

Reviews

There are no reviews yet.

Be the first to review “End stop upgrade – inductive”

Your email address will not be published. Required fields are marked *

Do you have a question about this product? fill in the form and i´ll get back to you asap.

*
*